With ends NO mounts
Heavy duty housing centers are constructed from .141” mild steel with a heavy duty .282” face plate. Tube insertion locations are slotted to allow complete and secure welding of the tubes to the housing. Internal plates gusset the housing and provide internal support to the ends of the tubes. The cover is designed to provide the clearance necessary for cases with heavy duty main caps and also allowing the use of 9 1/2” gear sets.
The housing is fitted with fill and drain plugs, tubed with your choice of .250” wall 3” or 3 1/4” mild steel tubing, and choice of housing ends. Larger tubing is stronger, but your intended mounts may dictate tube diameter. Since the builder will be installing their own mounts, extreme care must be taken during the welding process as housing end alignment can be compromised. An alignment jig should be used afterwards to ensure that warping did not occur.
Includes: 3 1/4 OD tubes, fill & drain, and upper control arm mounts and choice of housing ends
Lower control arm and coil spring mounts NOT INCLUDED
Beefcake Racing is an Authorized Dealer for Strange Engineering Components, call 1-855-827-7223, 9am-9pm EST
CA Residents: WARNING: Cancer and Reproductive Harm www.P65Warnings.ca.gov
