Designed Specifically For Drag Racing
Ford 8.8 rear brake kit for OEM 86-93 Mustang 8.8 ends with soft metallic pads
A considerable amount of weight is eliminated in the steel hat area. The Strange rotor is only .125” thick in the mounting surface and has additional lightening holes on the side and top of the hat. The slotted rotor is lighter than OEM and most other aftermarket rotors.
The one piece design eliminates mounting bolts that conduce binding and require constant torquing and/or cumbersome safety wire. It provides superior dissipation of heat created by braking- due to one integral design. It accommodates several axle bolt circles. It can be re-surfaced to eliminate brake pad material build-up.
4-Piston Directional Caliper
Lightweight aluminum calipers allow pad loading and wear to be balanced against the natural changing temperatures across the pad face. Coupled with superior Strange caliper bridge-bolt strength, the dissimilar piston sizes allow for optimum braking, feel, and more consistent pad wear. The caliper also features anti-rattle clips and stainless steel pistons that are corrosion resistant.
This Ford 8.8 rear brake kit fits OEM 1986-1993 Mustang 8.8 housing ends with 2.50″ of backspacing. It must be used with Strange Mustang C-Clip Eliminator Kit (A1090)
Application
Brake Kit for OEM 1986-1993 Mustang 8.8 Housing Ends
Requires
- Strange axles and C-Clip Eliminator Kit
- 5 lug bolt pattern
- 2.500″ brake offset
Includes
One Piece Forged Steel Rotors – B2792 / B2793
• Directional slots increase air flow and reduce weight
• One piece design eliminates bolts & safety wire
• Hat section drilled & milled to further reduce weight
• 4 1/2″, 4 3/4″ & 5″ Uni-Lug bolt circles for both 1/2″ & 5/8″ studs
Four Piston Directional Calipers – B5002 / B5004
• Aluminum bodies drastically reduce weight
• 1.625″ & 1.750″ pistons vary pressure decreasing pad taper
• Stainless steel pistons resist corrosion
• Anti-rattle clips reduce brake pad vibration and noise
Soft Metallic Brake Pads – B5010
• Provides the best starting-line cold holding power
• Recommended for vehicles going 150 MPH or less in the 1/4 mile
Aluminum Caliper Mounts
• Billet one piece design
• Eliminates bolts, spacers & nuts that require periodic maintenance
Brake Kits With Options Are Not Available For Online Orders
Please call us direct to place an order
Need More Wheel Clearance?
Low Profile Caliper Option – OPRB10
Want Billet Calipers?
Red or Black Billet Caliper Option – OPRB07
Brake Hoses & Lines Are Not Included
Calipers are tapped 1/8″ NPT and supplied with male 3 AN fittings
CA Residents: WARNING: Cancer and Reproductive Harm www.P65Warnings.ca.gov
