1968-72 A-Body LS Swap Engine Mounting Bracket Kit- Stock Position
Install Notes:Compatible with the following accessory drive systems: Holley or stock F-body/GTO (GTO alternator not compatible, must be relocated or replaced with an F-body alternator) Corvette (excluding the A/C compressor/bracket, which must be relocated) Truck (must use smaller 5" diameter power steering pump pulley and stock Denso A/C compressor without rear pressure sensor) These engine brackets ARE NOT compatible for use with the stock vehicle A/C evaporator case. Use factory Chevelle crossmember to install all transmissions other than 4th-gen F-body T56/T56 Magnum and 4L80/4L85
These Hooker BlackHeart engine swap mounting brackets facilitate the installation of an GM LS motor into a 1968-72 A-Body as part of your LS swap project. This mounting bracket kit is part of the most comprehensively engineered system of mounting components, headers and exhaust systems available for this application. The entire Hooker BlackHeart swap system is designed to decrease your total swap installation effort and cost, while increasing the engineered quality of your vehicle and compatibility of these components with other popular aftermarket components.
LS Oil Pan 302-2 can be used with these mounts
** Please read the provided instructions thoroughly before attempting installation.
CA Residents: WARNING: Cancer and Reproductive Harm www.P65Warnings.ca.gov
