The Driveshaft Shop 1-Piece 4" Aluminum Driveshaft is now available for the LX(Charger/ 300c/ Magnum) platform. This single shaft is the same design that we have been using in most modern muscle cars for the last 2 years and is a proven and trouble free shaft for these cars. This shaft will replace the stock 2 piece shaft and eliminate the disconnected feeling you get from the stock shaft with its Giubo (rubber drive) and soft hanger bearing rubber. The stock shaft has to have the Giubos twist, then the hanger bearing moves up and only after all this happens the car will start to move. With this new Aluminum 1-Piece that uses a 1350 joint on one end and a Custom CV on the other will make the car feel more connected or more athletic. The response from the gas pedal will be more responsive and will increase 60ft times at the track. This shaft will require a small spacer installed under the front mount of the diff (simple as removing the bolt and slipping it in) to ensure clearance on the rear section of the shaft. This is balanced like all shafts on our 9500rpm balancer so you know its done to the best standards available today.
FEATURES: • 1350 u-joint
• Custom 108mm CV with high speed boot and special grease
• Spline made from 300m and installed into aluminum head for superior strength and lightweight
• Balanced on high speed machine
• Comes complete with all high grade hardware
• Rated for 1000HP+
Beefcake Racing is an Authorized Dealer for The Driveshaft Shop, call 1-855-827-7223, 9am-9pm EST
CA Residents: WARNING: Cancer and Reproductive Harm www.P65Warnings.ca.gov
