Cornerstone Performance Solutions is proud to present our Dodge Challenger and Charger Lease package bundle kit! This kit fits the 2015-current 6.2 and 6.4 Liters! This is the perfect package for the "lease" in your life. With tasteful mods that will bring out the forgotten power that was left on the table. Let us get that Dodge 6.2 or 6.4L sounding and running like it should have been.
This bundle kit comes ready with some awesome parts and features the following parts all in one awesome package!
This Package includes
- Cornerstone Midpipes - CPS-MPK-6264-CC
- JLT Intake - CAI2-DH64-11
- JLT Catch Can - 3063P-B
Cornerstone Midpipes
This Stainless Midpipe System fits the 2015-current 6.2L & 6.4L Hemi and comes with all the hardware needed for a drill-less installation. These 3" pipes feature smooth mandrel bends for increased exhaust flow and is designed to bolt up to your stock exhaust manifolds, thus maintaining the factory connection point in front of the X-Pipe. This system is made of stainless steel and is proudly manufactured in the USA!
JLT Catch Can
- 3oz Capacity
- Solid billet construction.
- OEM Style quick connect PCV fittings
- Multi-stage filter system designed to collect the finest of vapors and drop them into the easily removable bottom while allowing clean air to pass through to the intake.
During the process of venting crankcase pressure back through your intake track, large amounts of oil, in the form of vapors, intake tube, intake manifold runners and even dilute your gas, lowering its octane level this means you can not only be leaving power on the table but also hurting your engine. Milled from solid billet aluminum this is a rock-solid piece that not only does its job but looks great while it does it. The JLT catch can features a knurled tank base for easy removal to drain the spent oil and an O-ring seal to prevent any leaks. The hold of the catch can holds 3 oz of fluid, while that may not sound like a lot, you shouldn’t see that much oil in your PCV system. Drain it every 2000-3000 miles and you will never come close to filling it.
JLT Intake
The JLT intake that comes in the kit includes a fully Roto Molded airbox that has an opening in the front to grab fresh air from the grille/headlight area and also seals to the hood. This is done to provide the best air possible that then gives the best performance possible.
The filter that is used in the JLT intake is a custom-built design made by S&B. It has a built-in bell mouth for super smooth and fast airflow as well as huge 1 inch deep pleats that allow for more surface area than filters that look much bigger.
The intake tube is roto-molded plastic with a huge 5" filer opening for superior airflow. With a mouth that is 4 inches at the throttle body end, it is ready for any larger throttle bodies that may come in the future.
Note: This kit requires no additional tuning but to get the most out of your modifications
CA Residents: WARNING: Cancer and Reproductive Harm www.P65Warnings.ca.gov
