Looking for a Dodge Hellcat intake with massive gains?
Look no further! Our Precision Hellcat intake is packed with quality, visuals & dyno-proven results. We took our R&D to the literal drawing board and looked to maximize every aspect of the stock intake. We took our scans and used every cm of available space to create a stunning and purposeful airbox that looks great and outperforms the stock & other aftermarket intakes without reducing flow. Then we added a 4.5" mandrel bent intake tube for as little restriction as possible. Then we styled it with a laser-cut Cornerstone Performance Solutions logo and powder-coated it to give a long-lasting and immaculate finish. This intake is not slapped together by any means, this is the result of months of R&D & design, Enjoy!
Features & Benefits of the Closed Box Cornerstone Performance Solutions Cold Air Intake for the 17-22 Hellcat
- 4.5" mandrel bent intake tube
- NO TUNING REQUIRED
- No Cutting or Modifications for Installation
- Uses factory mounting locations
- 7" Oiled filter (30% greater surface area than stock)
- Retains the factory fresh-air (Ram Air) inlet from the front grille/headlight
- Powder-Coated with Prismatic Powders premium powder coat
- 100% Designed, Fabricated & Finished in the U.S.A.
- Average installation time of 30 minutes
- 19+ HP Gain over stock (Dyno Proven)
- 10+ FTLB Gain over stock (Dyno Proven)
- Kit includes hardware for both PCV system configurations
- Laser-cut closed box enclosures
- High-Quality silicone boot & Hardware
- Limited Lifetime Warranty on all hard parts
What is included in the Closed Box Cold Air Intake for the 17-22 Hellcat from Cornerstone?
- 1x - Powder-Coated intake tube w/ provisions
- 1x - Custom 7" Oiled Filter
- 1x - Assembled & Powder-Coated Intake Box w/ Lid
- 1x - High-Quality Reinforced 4-Ply Silicone boot
- 1x - Short PCV hose
- 1x - Long PCV hose
- 2x - 4.5" Stainless Steel T-Bolt Clamps
- 2x - Stainless Steel Worm Gear Clamps for PCV hose
Dyno Test Results for our Closed Box Cold Air Intake for the 17-22 Hellcat
All testing was performed on a stock 2020 Dodge Hellcat Charger Widebody with zero other modifications. Testing was performed in a climate-controlled facility on the same day with the only changes being adding our aftermarket hellcat intake to the car. Stock results- 4 Runs back to back yielded us a maximum of 632WHP and 674FTLBS Results with our intake added
4 Runs back to back yielded us a maximum of 651WHP and 684FTLBS. A 19WHP & 10FTLBS GAIN!!!
We noticed during our testing that the stock hellcat intake run after run got heat-soaked really bad and took quite some time to recover back to our original starting point which was 110 degrees. We tried everything we could to try and heat soak our intake run after run to try and replicate the heat gains we saw with the stock airbox and couldn't.
NOTE: May require a custom tune to receive maximum performance gains
CA Residents: WARNING: Cancer and Reproductive Harm www.P65Warnings.ca.gov
