INTAKE TUBE DESIGN
Using the original J&L CAI as a guide, we molded, sculpted and perfected everything until we had the best looking, fitting and performing system you can buy. The new J&L tube is 4 1/4" ID, roto molded plastic to resist engine heat and keep the intake air charge nice and cool. NO METAL TUBING HERE!! MAF and filter relocated into fender well for a cooler intake charge and can support 550-600 RWHP. Works with both 80mm and 90mm MAF's, no need to buy more parts when you upgrade to a 90mm MAF
MOLDED IN MAF
The best part of this new J&L Cold Air is we kicked the cool factor up a notch and molded a 105mm MAF housing right in the tube. Now you have a kit you can grow into and not have to buy a complete new kit when you reach 550-600 RWHP. Putting a Whipple, Kenne Bell or Eaton blower swap on your Cobra? Simply drill out the pre molded plug on the MAF block located on the bottom of the tube, discreetly out of sight. Install your SCT MAF sensor electronics, add our huge 4.5 X 12” S&B Powerstack filter and you’ve now changed your J&L Cold Air Intake into a J&L High Boost 12” Intake. Molding the MAF into the tube makes for a much smoother air flow with no couplers, reducers or separate MAF housing and can support 800+RWHP for only the cost of the 12” upgrade kit, $60.00.
GAINS: 14-18 RWHP are typical with this kit.
EASY INSTALL: The new design, detailed instructions and online video instructions helps make this an easy install.
Note: Will not fit with most strut tower braces or aftermarket K-Members.
KIT INCLUDES:
• J&L plastic intake tube
• Silicone Coupler
• Silicone reducer
• Apron Plate
• 4x6 S&B powerstack air filter
• Silicone MAF spacer
• MAF adapter
• MAF adapter gasket
• HD Clamps & all needed hardware
MAINTENANCE: To properly clean your filter, we recommend the S&B Precision II Cleaning & Oiling Kit. *TIP* by purchasing a 2nd air filter you can simply swap filters when it's time to clean it and not be rushed. Clean the first filter and it's ready when it's time to change again.
J&L Pre-Filters are now available for most intake kits we carry, these filters are made for us by Outerwears, these prefilters are water repellent. They will increase your filter life and cut down on your cleaning intervals!
*The air filter is low in the bumper to get the coolest air possible. While driving in the rain is not an issue, you MUST be aware of flooded streets and deep puddles. *
This kit is street legal in all US states.
CARB Exempt ID: D-761-2
Fitment:
- 1996 SVT Cobra
- 1997 SVT Cobra
- 1998 SVT Cobra
CA Residents: WARNING: Cancer and Reproductive Harm www.P65Warnings.ca.gov
