ALL NEW, J&L Cold Air Intake for 2018-2021 Jeep TrackHawk. Bad to the Bone all on it's own, but we make it better (and badder)!
This kit includes a roto molded plastic heat shield that has a opening in the front to grab fresh air from the grille/headlight area and also seals to the hood.
Our air filter is a custom built design made by S&B. It has a built in bell mouth for super smooth and fast air flow as well as huge 1" deep pleats for more surface area than filters that look much bigger.
The intake tube is roto molded plastic with a huge 5" filer opening for superior airflow and NO heat soak like metal tubes.
With a mouth of 4.5" at the throttle body end, it is ready for any larger throttle bodies that may come in the future.
FINISH: Standard finish is an OEM looking black textured plastic.
HEAT SHIELD: Includes our large ABS plastic heat shield to block engine heat at idle and low speed. It uses a large area to make sure the filter has tons of cool air and uses the factory fresh air inlet from the bumper to keep temps cool as stock
KIT INCLUDES:
- J&L Roto Molded Plastic Intake Tube
- Silicone Reducer
- 5x7 S&B Powerstack Air Filter
- J&L Roto Molded Heat Shield with fresh air feed
- HD Clamps, all needed hardware
GAINS AND TESTING: 30-35 RWHP & 20-25 RWTQ are typical with this kit.
TUNING: No tuning required
EASY INSTALL: The design, detailed instructions and online video (see below) helps make this an easy install
J&L Pre-Filters are now available for most intake kits we carry, these filters are made for us by Outerwears, these prefilters are water repellent. They will increase your filter life and cut down on your cleaning intervals!
Carb Status: CARB E.O. No D-761-5 (2018-2020 ONLY) NOT CARB APPROVED FOR 2021
Fitment:
- 2018 Jeep Trackhawk
- 2019 Jeep Trackhawk
- 2020 Jeep Trackhawk
- 2021 Jeep Trackhawk
CA Residents: WARNING: Cancer and Reproductive Harm www.P65Warnings.ca.gov
